One of Outside columnist Jakob Schiller’s favorites, this jacket is made with burly, seven-ounce waxed sailcloth and lined with soft polyester. Like fine leather, it will develop a patina that looks great the more you wear it. “[It] will not only put up with years of chopping wood but will also look better afterward,” he writes.

Crews began using sump pumps and Shop-vacs to suck up the standing water as they waited for a plumber to install the new 6-inch drain pipe, Sant said.

(a) Diagram of voltage regulator circuit. (b–d) Waveforms of (b) Vout, (c) Vsw and (d) current into the inductor, with 4.0 V input voltage and 1 kΩ load resistance, measured using printed inductor. Surface-mount resistors and capacitors were used for this measurement. (e) Efficiency of a voltage regulator circuit using all surface-mount components vs. one with printed inductor and resistors, for various load resistances and input voltages. (f) Ratio of efficiencies of the surface-mount and printed circuits shown in (e).

The cozy wool upper on these slippers pairs beautifully with a rubber outsole for ultimate convenience when hanging out indoors or running out for a quick coffee. They can be worn with or without socks, and if you choose to do the latter, you won’t have to worry about stink, thanks to the odor-resistant nature of the wool.

No matter how warm your climate, printing on fleece is inevitable for nearly any screen printer. Cooler weather will dictate the quantity and product choice in this product category. Crewnecks, hoodies and zipper fronts are all on the menu for your fleece-consuming customers.

White inks in this range are engineered for IR flash drying, making it possible to print on dark fabrics. All inks show good viscosity stability on the screen, typically better than most conventional plastisols. This stability allows the use of fine mesh sizes, resulting in a reduction of initial production run losses by getting the first print right. The standard colors offer good wet-on-wet printing characteristics with up to eight printed layers possible without intermediate drying.

Slide the 13-millimeter-thick KryptoLok around your back tire and chainstays, then loop the included cable through the frame and front wheel before hooking it to the U-bar and clamping the whole thing shut. The entire system looks damn near unbreakable and can ward off all but the most determined thief.

Group Play ends on June 14th where 16 teams will be chosen from the six groups to play in the larger, single-elimination World Cup bracket. If all goes well for the U.S. team, they’ll be playing in the World Cup title match on July 9th, 2019.

The sessions range from kid-friendly events to adult BYOB workshops to fundraisers. Each session offers a pre-determined stencil, many of them with a holiday or community event theme. They also use water-based inks to help reduce the impact on the environment.

Microchip Technology Inc. MCP1640/B/C/D Data Sheet. < http://ww1.microchip.com/downloads/en/DeviceDoc/20002234c.pdf>, (2014). Date of access: 14 May 2015.

A new conveyor dryer from Workhorse Products provides the ability to dry both water-based and plastisol inks and adjust infrared heating elements; it also offers tablet touchpad controls so the operator can adjust or program three preset drying or curing programs for consistent, reliable results.

For years, Vasque has been known for its straight-out-of-the-box comfort and has made a substantial contribution to the world of leather hiking boots with its classic Sundowner. The sportier St. Elias has a full-grain all-leather upper with a Gore-Tex waterproof liner, a soft EVA footbed for cushion, and a urethane shank for support and protection against sharp rocks.